Power lightning surge protectors 220v surge arrester surge suppressor

TRS-D20 type power lightning protector, 3P 20KA surge protector, surge switch, SPD surge arrester.

Product introduction

The surge protector is a lightning protection measure adopted by Zhejiang toer Electric Co., Ltd. for the electrical system. It is suitable for the N-S, NT-C, TH-C, TT, LT and other power supply systems of 50/60Hz 380V and below, which can be used as the equipotential connection at the interface of LPZ1, LPZ2 and LPZ3.
The design is based on IEC61643-1 and GB18802.1. It is an electronic device that provides security protection for all kinds of electronic devices, instruments and communication lines.

Product specification

Product features

1. new technology, high energy, gap discharge electrode N-PE.

2. leakage current is small, the response time is fast, and the residual pressure is low

3. copper fittings have good electrical conductivity

4. the speed of response is 0.001 seconds, and the voltage is controlled in the range that the equipment can withstand.

Notice of product

1. surge protector is installed with 35MM standard guide rail

2. standard RJ45 interface can be conveniently connected to the front end of the protected equipment.

The grounding path should be as short as possible, and the length should not exceed 1.5 meters.

3. identify the input / output interface identifier of the lightning protector, input the external line and output the connection device.

4. lightning arresters are connected in series between protected equipment

Product Installation

With 35mm standard DIN-rail mounting, connecting copper stranded conductor is 2.5~35mm²

At front of spd each pole must be setted protection---used fuse or miniature circuit breaker lightning current SPD protection,after SPD breakdown to short circuit protection.

SPD install on protected line(equipment) to the front and connected to the supply line. A class products install in the building home-entry line hold larger surge current total distribution box. B, C class products most install on the floor distribution box, D class products close to the front-end equipment that smaller surge current, smaller residual voltage place.

Working principle of product

Under normal working condition, the lightning protection module is in a high resistance state. When the power supply line has lightning invasion or operation transient overvoltage, the lightning protection module will immediately pass through the response speed of nanosecond level, and limit the lightning overvoltage or transient overvoltage to the voltage range allowed by the electrical equipment, thus protecting the normal operation of the electronic equipment. After that, the lightning protection module quickly returns to the high impedance state without affecting the normal power supply of the grid.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.