20KA surge arrester transient voltage protector SPD power surge protector 220v

Single-phase power surge protector Lightning protection 1P Single line protection

Brief introduction

Surge protector is the lightning protection measures adopted by Zhejiang toer Electric Co., Ltd. for the electrical system. It is suitable for the AC 50/60HZ, the rated voltage 220V/380V power supply system to protect the indirect lightning and direct lightning impact or other instantaneous overvoltage surge, suitable for home housing and the third industry. And the requirements of electric surge protection in industry.

Product features

1. new technology, high energy, gap discharge electrode N-PE.

2. copper fittings have good electrical conductivity

3. with the power status indication, indicating the working state of surge protector.

Product specification

Working principle of product

Surge protector is an indispensable device in lightning protection of electronic equipment. It used to be called "lightning arrester" or "overvoltage protector". The function of surge protector is to limit the transient overvoltage to the power line and signal transmission line within the electric pressure range that the equipment or system can bear, or to inflow the powerful lightning discharge into the ground. The protected equipment or system is not damaged by impact.

Product Installation

With 35mm standard DIN-rail mounting, connecting copper stranded conductor is 2.5~35mm²

At front of spd each pole must be setted protection---used fuse or miniature circuit breaker lightning current SPD protection,after SPD breakdown to short circuit protection.

SPD install on protected line(equipment) to the front and connected to the supply line. A class products install in the building home-entry line hold larger surge current total distribution box. B, C class products most install on the floor distribution box, D class products close to the front-end equipment that smaller surge current, smaller residual voltage place.

Use of attention

1. lightning protection device IN as input and OUT as output, the input end is connected with the outside, and the output end of the input end of the connecting device is protected.

2. lightning protector's input port (IN) is connected to the signal channel, and the output terminal (OUT) is connected with the input end of the protected device, so it cannot be connected to the reverse side.

3. the relative humidity of the installation site is not more than 50% when the relative humidity of the air is 40.

Product packaging: Carton packing

Transportation method

1. Express company: FEDEX,UPS,DHL,TNT

2. Trains, ships, aircraft transport

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.