Non Bearing Through Hole Encoder , Incremental Rotary Encoder 5000rpm

Through hole incremental encoder dimension 100mm shaft 63mm Z100 Non-bearing encoder

Matters needing attention

1. Must choose the power supply voltage: DC5V or DC8-30V

2. Must choose leaf spring plate model number if you select hollow shaft encoder

3. Please advise the motor speed (RPM) that you actually use

4. If you have any other requirements, please provide detail parameters

Model Number of Z100Series to select

Z100-J12C2500/8B40

Z100-C12E2500/10B42

Z100-J12C2500/16B45

Z100-C12E5000/8B48

Z100-J12C5000/10B46

Z100-C12E5000/16B50

Z100-J12C10000/8B52

Z100-C12E10000/10B55

Z100-J12C10000/16B60

Z100-C12E52500/8B63

Z100-J12C2500/10B40

Z100-C12E2500/16B42

Z100-J12C5000/8B45

Product introduction

Principle of encoder

Today most incremental encoders have a Push-Pull (HTL) or RS422 (TTL) output driver, these have replaced most of the older output circuits like Open Collector NPN, Open Collector PNP, Voltage Output.

Push-Pull (HTL) circuits, also known as Totem Pole, provide a signal level which corresponds to the applied supply voltage. The supply voltage typically ranges from 8 to 30 VDC.

With proper connections you can use the Push Pull interface to replace true open collector circuits by using an external diode connected in a way to limit the direction of the current for RS422 (TTL) circuits provide a constant 5 V signal level that is not dependent on the supply voltage. Two supply voltage ranges can be selected: From 4.75 to 5.5 VDC (can be used to replace open collector output drivers) or from 8 to 30 VDC. Using differential signals the output fully complies to the RS422 standard.

The differential outputs have the highest frequency response capability and the best noise immunity. To ensure this the receiver should also be a differential.

Replacement of Older Output Drivers

A logic gate interprets certain input voltages as high (logic 1) or low (logic 0).

TTL (transistor-transistor-logic): A signal above 2 V is interpreted as logic 1 and a signal less than 0.8 V is interpreted as logic 0. The output voltage ranges between 0-5 V.

HTL (high-threshold-logic): A signal above 3 V is a logic 1 and a signal less than 1 V is a logic 0. The high output signal level is dependent from the supply voltage. Because of the higher voltage difference between logic 0 and 1, the HTL logic is more immune to interference and more resistant against electrical noise.

Shanghai Hengxiang Optical Electronics Co., Ltd. is a high-tech enterprise, specializing in the creation, research, production, and marketing of high-precision optical encoders.

We have a mature independent research and development capability, which enables to customize the production of exclusive models based on the needs of new development technology products.

We founded in 2001 and exported products to domestic and overseas after 21 years of sedimentation.

We mainly engaged in the encoder, optical lens, germanium products, etc. The strict control of product quality and high precision and high standard of deep processing technology serve the elevator, motor, CNC, textile, robot, wind power, medical, assembly line equipment, and other automation technology industries.