High Voltage 8Khz ESC Brushless Controller RC Surfboard 120V 500A

120V 500A High Voltage ESC Brushless Driver frequency 8Khz For RC Surfboard 150V Capacitor

Basic information:

Feature:

Battery voltage 1S=4.2V

The ESC firmware can be updated by the user.

It can be connected to the programming box or connected to the computer through the USB cable, which is very convenient to set various parameters of the brushless ESC.

Single cell protection shutdown voltage, adjustable from 0.1V.

The motor advance angle is from 0 to 30 degrees and can be adjusted step by step.

The three types of throttle response curves can be set to different acceleration sensations.

With reverse function, and reverse delay time is adjustable.

With forward/reverse power limit function

Li-MH/Li-Pofrom 2.0-3.6V, Ne-Cd/Ne-0.4-1.0V, LiFefrom 2.2-2.8V.

It has automatic throttle detection and manual setting of a fixed value function.

Over temperature protection 110 ° C.

The remote control signal is automatically turned off after 3 seconds of loss.

.The anti-spark wire is built in a bullet connector and a 10 ohms resistor. you can separate it
into two wires. You must connect the end of the wire to the battery negative. when you
connect the ESC with the battery, you can connect the red wire of ESC to the positive pole
of battery at first. Then connect the anti-spark wires well. The last step is to connect the
black wire of ESC to the battery’s negative pole. If do so, no spark will be generated, and
this will protect the main bullets connector from spark damage.

Setting function value:

1. Reverse: On/Off.

2. Timing:0°,1°,2°,3°,4°……30°.

3. Frequency: 8KHz, 16 KHz, 32 KHz.

4. Acceleration: Soft / Medium / Hard.

5. Accumulator type:NiCd/NiMh,Li-Ion/Li-Pol,LiFe.

6. NiCd/NiMH CUTOFF:×0.05,0.4V,0.5V,0.6V,0.7V,0.8V,0.9V,1.0V.×0.05 means the cut off voltage is 5% the voltage while connecting.

7. Number of cells:Auto,2S,3S,4S,5S,6S,7S,8S,9S,10S,11S,12S,16S.

8. LiIo/Pol CUTOFF:2.0V,2.1V,2.2V,2.3V,2.4V,2.5V,2.6V,2.7V,2.8V,2.9V,3.0V,3.1V,3.2V,3.3V,3.4V,3.5V,3.6V.

9. LiFe cutoff:2.2V,2.3V,2.4V,2.5V,2.6V,2.7V,2.8V

10. Cut Off Type::Slow down,Hard. l

11. Power limited forward: Off, 75%, 50%, 25%.

12. Power limited reverse: Off, 75%, 50%, 25%.

13. Delay time when direction convert: 0.25S, 0.5S, 0.75S, 1S, 1.5S, 2S, 3S, 5S.

14. Reverse point:Auto,fixed 1.0mS,fixed 1.1mS,fixed 1.2mS,fixed 1.3mS.

15. Forward point:Auto,fixed 1.7mS,fixed 1.8mS,fixed 1.9mS,fixed 2.0mS.

16. Throttle curve: Logarithmical,Linear,Exponential.

17. Rotation direction: Left, Right.

18. Timing monitor (TIMING MONTITOR): ON, Off.

Note:the red mark is the factory default value,you can setting function value by youself.

.

Shenzhen Flier Electronics Co., Ltd. is a high-tech enterprise specializing in the research, development, production and sale of electronic products in the field of robots and UAV aeromodelling.The company's professional products are the electronic speed controller(ESC) for DC brushless motor.

Founded in 2004, the company is located in the busy section of Xixiang Street in Shenzhen. After years of development, the company has now become a professional manufacturer of brushless electronic speed controller with a wide range of varieties in China.

Our company's ESC series products are relatively advanced in the market, with more functions.It can communicate with the computer in two directions. The computer can automatically identify the type of the ESC. The computer can read the parameters of the ESC and program them. It can also be updated the firmware. Some of ESC can load the popular open source firmware.

ESC can be controlled via PWM, the DC voltage, RS232,RS485 . Some ESCs can be controlled via CAN bus too.

The company's ESC products cover ESC for marine, ESC for airplane, ESC for helicopter, ESC for multicopter, ESC foe car, ESC for surfboards, ESC for skateboards and Industrial controller.

Power ranges from 1000W to 30KW, and low voltage series voltage ranges from 12V to 30V(2S-8S).middle voltage series voltage ranges from 30V to 60V(8S-14S).high voltage series voltage ranges from 60V to 120V(14S-28S).supper high voltage series voltage ranges from 120V to 500V. the current ranges from 100 amps to 500 amps.Ultra-high ESC products are our absolute strength.

Our products have independent intellectual property rights. If necessary, we can make firmware according to customer's requirements. Our company also has a strong ability to develop new products, and has developed or is developing some related electronic products, so as to maintain the technological leading edge in this field.

The company's products have strict quality control standards, to ensure the optimization of product quality. At the same time, according to the differences of customer needs, we constantly enrich product categories, improve product functions, improve product quality and optimize product mix in order to provide customers with professional products and quality services.

We are in line with "quality innovation to win the market, the good faith management cast the future."

philosophy, rigorous and meticulous work style, high cost-effective products,  We willing to make

the friend and sincere cooperation, create brilliant with all over the world!