120KA power surge voltage protection SPD 3 phase surge protection device

Lightning protector device , Rated Operating Voitage 275V , 4P three-phase power

Product introduction

Surge protector is the lightning protection measures taken by Zhejiang toer Electric Co., Ltd. for the electrical system, which provides safety protection for all kinds of electronic equipment, instruments and communication lines. It is mainly used to limit overvoltage and discharge electric current.
Surge protector is usually connected with protected equipment. When overvoltage is generated, it can play the role of shunting and voltage limiting. To prevent excessive current and voltage damage to equipment, play the role of protection devices.

Product specification

Product features

1. the speed of response is 0.001 seconds, and the voltage is controlled in the range that the equipment can withstand.

2. low output residual pressure to further ensure safety

3. core components are strictly screened, stable performance and reliable operation.

4. built-in overheating and temperature control circuit breaker

Notice of product

1. Determination of discharge current path

2. the wire that marks the extra voltage drop caused by the device terminal.

3. grounding lines should be short, thick and straight, so as to reduce the influence of distributed inductors on the ability of lightning electromagnetic pulse.

4. this product needs no special maintenance. The lightning arrester should be checked regularly, especially in the thunderstorm season and the whole thunderstorm period. When the system fails to suspect the lightning arrester, the lightning arrester can be dismantled and rechecked. If the system is restored to normal after the restoration to the state before use, the lightning arrester has been damaged and must be replaced immediately.

Working principle of product

Under normal working condition, the lightning protection module is in a high resistance state. When the power supply line has lightning invasion or operation transient overvoltage, the lightning protection module will immediately pass through the response speed of nanosecond level, and limit the lightning overvoltage or transient overvoltage to the voltage range allowed by the electrical equipment, thus protecting the normal operation of the electronic equipment. After that, the lightning protection module quickly returns to the high impedance state without affecting the normal power supply of the grid.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.
Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Product packaging:Carton packing

Transportation method

2. Trains, ships, aircraft transport

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.